![]() ![]() # There are two LCD resolution modes, choose one of the two to execute. Note: Please make sure your Pi is connecting to the internet. Then open a terminal to install the touch driver which can be found in the /boot/ directory. How to write an image to a micro SD card for your Pi? See RPi Image Installation Guides for more details)ģ) Copy the LCD driver to the micro SD card (or copy the driver to the system of Pi using a USB drive).Ĥ) Append the following lines to the config.txt file which is located in the root of the card: max_usb_current=1ĥ) The LCD will display after booting up. Driver installationġ) Download the Raspbian / Ubuntu Mate image from Raspberry Pi website and extract it on a PC.Ģ) Connect your micro SD card to the PC and write the image to the card using Win32DiskImager. use the Ready-to-use image file of which LCD driver was pre-installed. install driver to your Raspbian/Ubuntu Mate OS. You can enable the touch in two ways: Method 1. Turn on the "backlight" switch on the back of the LCD.You should connect the LCD to Raspberry Pi Model B or Raspberry Pi Zero with an HDMI cable rather than an HDMI Connector. ![]() ![]() Connect the HDMI Connector to both the HDMI interfaces on the LCD and the Pi.There are 40 pins on Raspberry Pi Model A+/B+/2 B/3 B but only 26 pins on the LCD, so you should pay attention to connecting the pins to your Pi accordingly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |